WUPP CS-1846A1 1 Pair Heated Handle Grips Hot Grips Handle Warmer for NIU Electric Scooters

• The inner diameter of the right-hand handlebar without a throttle core is larger, which is suitable for models where the throttle core cannot be disassembled
• The product adopts a horizontally wound structure of heating wires, which is much more complex than other structures on the market However, the force is evenly distributed during rotation and has excellent comfort. The heating power and electricity consumption are only half of similar products, and the heating effect is better. It is a truly high-efficiency and energy-saving electric heating handle
• The handle is made of high-temperature-resistant nitrile rubber and is molded in one go. It has an ultra-thin special switch for electric heating handles and a removable cover that can be sealed or opened for free switching
• The advanced electronic temperature control system consumes no power and can better protect the battery. The high-quality handlebar switch is more exquisite than the original handlebar
• The product wires are sheathed in silicone and can be used in extremely low environments. Silicone has particularly good aging resistance and will not age with time
• Exclusively designed throttle buckle to fit some models of NIU scooters

Specification:

• Model: CS-1846A1
• Net weight: 242g
• Material: nitrile rubber
• Handlebar length: left-hand handle: 127*36mm; right-hand handle: 137*36mm
• Applicable pipe diameter: 22mm
• Input voltage: DC12V
• Product power: 15W-35W adjustable
• Working ring mirror temperature: -20℃ - 50℃
• Handle type: Sealing or opening electric heating handle
• Switch type: multi-level adjustable switch
• Scope of application: Suitable for NIU N1S, U+, U+B and some similar right-hand scooters

How to Install:

• 1. First remove the left hand handle of the original car
• 2. Wet the inner hole of the left hand handle with soapy water. The twisting range should not be too large during installation. There should be enough room for rotation of the power cord of the right hand handle.
• 3. When installing the balance iron on the left hand handle, adjust the position of the balance iron to be slightly separated from the handle. Do not squeeze the handle when tightening the screw. If the left hand handle slides on the steel pipe during use, remove the balance iron and tap a few points from the end of the handle. Glue fixation
• 4. You only need to remove the soft rubber for the throttle, remove the soft rubber and install the right handlebar. The oil twister does not need to be removed.
• 5. Wiring method: The red wire is connected to the positive pole of the power supply, and the black wire is connected to the negative pole of the power supply (Note: Do not connect reversely)

Note:

• 1. Do not twist the handle excessively when installing the left-hand handlebar. Excessive twisting will cause the heating wire to shift. The handlebar only replaces the rubber handle outside the original car's throttle ring, not the throttle ring itself. If you are not familiar with the car's circuit or Riders with poor hands-on skills are advised to find a car dealer for installation.
• 2. For models with a balance iron, please adjust the installation position of the balance iron. Do not squeeze the handle when tightening the screws. The balance iron is slightly separated from the handle. If the installation position of the balance iron cannot be adjusted, please add a spacer between the balance iron and the handle. Excessive squeezing of the handle will cause difficulty in turning the handle switch, and abnormal damage such as the heating wire extruding from the handle's surface.