WUPP CS-095K1 Motorbike Handlebar Heated Grip Style-22 Electric Heating Sleeve without Throttle Core

• The right handlebar without throttle core has a larger inner diameter and is suitable for models where the throttle core should not be removed
• The product adopts the structure of transverse winding of heating wire, which is much more complicated than other structures on the market, but the force is even when rotating and has excellent comfort
• The heating power and electricity consumption is only half of similar products, with better heating effect, it is a real energy efficient electric handlebar
• The handle is made of high-temperature resistant nitrile rubber molding, an ultra-thin special switch for electric heating handgrip, removable cover, that can be sealed through the mouth to freely switch the use
• Advanced electronic temperature control system, does not consume power, can better protect the battery, quality workmanship handlebar switch, to be more exquisite than the original handlebar
• Product wire with silicone sheath can be used in very low environments silicone aging resistance is particularly good, and will not get old with the use of time (the old wire without silicone protective sleeve)

Specifications:

• Product Model: CS-095K1
• Product Weight: 212g
• Handle Length: Left Handle: 125*35mm; Right Handle: 127*35mm
• Handle Diameter: 22mm
• Input voltage: 12V
• Handle Type: Sealable and pass-through electric handle

Installation Instructions:

• First, remove the original left handlebar.
• The left handlebar inner hole with soapy water to wet, the installation of twisting amplitude can not be too large, the right handlebar power cord should be left enough to rotate the remaining line.
• When installing the balance iron on the left handlebar, the balance iron position is adjusted to be slightly separated from the handlebar, and the handle should not be squeezed when tightening the screws, and if the left handlebar slides on the steel pipe during use, remove the balance iron and fix it with a few drops of 502 adhesives from the end of the handlebar.
• Throttle only need to dial the soft rubber, remove the soft rubber after the installation of the right handlebar can be, torsion of the oil does not need to be removed.
• Wiring method, the red wire connected to the positive pole of the power supply, and the black wire is connected to the negative pole of the power supply (note: can not be reversed).

Note:

• When installing the left handlebar, do not twist the handlebar too much, too much twisting will cause the electric heating wire displacement; handlebar only replace the original throttle ring outside the rubber handle part, do not replace the throttle ring itself, unfamiliar with the car circuit or poor hands-on ability of the enthusiasts recommended to find a car dealer to install;
• With balance iron models, please adjust the balance iron installation position, do not squeeze the handlebar when tightening the screws, and the balance iron and the handlebar slightly apart. If the balance iron installation position can not be adjusted, please add shims between the balance iron and the handlebar to separate, excessive pressure on the handlebar will cause the handlebar switch Toggle difficult, electric wire extrusion handlebar surface, and other abnormal damage.