For Arduino UNO R3 Upgraded Project Complete Starter Set RFID Stepper Motor Learning Kits

Package included:

• 1 x Uno R3 Board +1 x USB Cable
• 1 x Uno R3 Extension Baord
• 1 x GPIO Extension Board
• 1 x Connecting Cable
• 1 x Breadboard
• 1 x Mini Breadboard
• 10 x 3mm Red LEDs
• 10 x 3mm Green LEDs
• 10 x 3mm Yellow LEDs
• 1 x 5mm RGB LED
• 5 x Buttons
• 20 x (330 ohm + 1k ohm +10k ohm) Resistor
• 1 x 1K Potentiometer
• 1 x 10K Potentiometer
• 1 x 2.54mm Elbow 40 Pin Header
• 1 x 2.54mm Straight 40 Pin Header
• 1 x 5516 LDR (Photoresistor)
• 1 x Ball Switch
• 1 x Active Buzzer
• 1 x Passive Buzzer
• 1 x MAX7219 Chip
• 1 x 74HC595 8bit Shift Register
• 1 x LM35 Temperature Sensor
• 1 x SS8050 NPN Transistor
• 1 x 1838 Infrared Receiver
• 1 x Infrared Sender
• 1 x Infrared Phototransistor
• 1 x Infrared Remote controller (BatterriesNot Included)
• 1 x Stepper Motor
• 1 x Servo Motor
• 1 x 1602 LCD
• 1 x 1-Digit Eight-segment Display
• 1 x 4-Digit Eight-segment Display
• 1 x 8*8 Dot Matrix Led Display
• 1 x Stepper Motor Driver Board
• 1 x Sound Sensor Module
• 1 x PS2 Joystick Module
• 1 x RTC Module (Batteries Not Included)
• 1 x Relay Module
• 65 x Jump Wires
• 10 x Female-Female Dupont Wires
• 10 x Male-Female Dupont Wires
• 1 x 9V Battery Holder (Batteries not included)
• 1 x Ultrasonic Range Detector
• 1 x Plastic Box (Container)